Posts Tagged ‘Sleeve Drafting’

Drafting Sleeves

Posted on August 5th, 2008 by by admin

3 STYLES Illustration shows sleeve gathered into a wristband, 1” wide. 1) Trace sleeve draft according to the outline of the draft HERE, diagram 6; then draft sleeve for this style 2 and 3) First trace front part of sleeve and open; then trace back of sleeve. 4) Make wristband 1” wide and the required [...]

Drafting Wing Sleeve

Posted on August 5th, 2008 by by admin

Deep Aarmhole Sleeves style 2 STYLES [WING SLEEVE DESIGNS] STYLE 1 This style features a 3-1/2” deeper armhole sleeve. Front has diagonal side dart. 1) Draft deeper armhole and wider shoulder as indicated. Draft side dart line; then mark sections A to C. Close up front and waist darts, spreading side dart as shown in [...]

Sleeve Drafting

Posted on August 4th, 2008 by by admin

3 STYLES Illustration shows sleeve with great amount of fullness at top, but fitted from elbow to wrist. 1) Use the 1-piece shaped sleeve pattern as a guide, and mark a line down 4” long from the shoulder notch. 2) Mark position for slash lines, 4” apart on either side of the sleeve; then draw [...]

Sleeve Drafting

Posted on August 4th, 2008 by by admin

STYLE 1 Illustration shows shoulder extended about 1-1/4” beyond the regular armhole. 1) Use the dress foundation of the front, back and sleeve as a guide. Cut off part of sleeve cap and apply to armhole at front and back for extended shoulder, as follows: First draw a line through center of sleeve; then mark [...]

Drafting Sleeve with Yolk

Posted on August 4th, 2008 by by admin

Yoke and Sleeve in One Illustrated shows shoulder extended about 1” beyond the regular armhole. The pad holds shoulder of yoke in position. The sleeve is in two parts with seam through center. 1) Trace the dress foundation of the front, back and sleeve; then draw the yoke seam lines on front and back, and [...]

Drafting the Push up Sleeve

Posted on August 4th, 2008 by by admin

2 STYLES-STYLE 3 Sketch shows 3/4 length sleeve with cuff pushed up toward the elbow. Sleeve has allowance for gathers to make it puff around the arm. In addition, the sleeve has an extra allowance for an inverted pleat in the back, to give it greater fullness at that point. 1) Draft sleeve 3-1/2″ shorter; [...]

Sleeve Drafting

Posted on August 4th, 2008 by by admin

3 STYLES Illustration shows 2-piece shaped sleeve. 1) Trace sleeve draft according to the outline of the draft on page 12, diagram 6: then shape sleeve below elbow, 2) Draw the under sleeve seam lines within the sleeve as illustrated. 3) To complete the upper sleeve, trace the front and back part Trace each section; [...]

Sleeve Drafting

Posted on August 4th, 2008 by by admin

3 STYLES Sleeve with 3 darts at shoulder 1) Trace sleeve foundation; then mark 3 dots at top of cap, 2-1/2” apart. 2) Draw slash lines, and mark sections A to E. 3) Slash cap on dotted lines, and spread sections as illustrated, raising the sections 1-1/2” at center and spreading evenly at top for [...]

Sleeve Drafting

Posted on August 4th, 2008 by by admin

3 STYLES Sleeve with band at top of cap. 1) Trace sleeve foundation; then make sections A to D 2” wide at top, 1-1/2” wide at bottom, and about 1” long. 2) Draw the remaining dotted lines as illustrated and mark sections E to J. Slash center of sleeve from top down between B and [...]